Descargar Imprimir esta página

Craftsman 917.9993A Manual Del Usuario página 17

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGINE
ENGINE SPEED
Your engine speed has been factory set.
Do not attempt to increase engine speed
or it may result in personal injury. If you
believe that engine is running too fast or
too slow, take your mower to a Sears or
other qualified service center for repair
and adjustment.
CARBURETOR
Your carburetor is not adjustable.
If your
engine does not operate properly due
to suspected
carburetor problems, take
your lawn mower to a Sears or other
qualified service center for repair and/or
adjustment.
IMPORTANT:
Never tamper with the
engine governor, which is factory set for
proper engine speed.
Overspeeding
the engine above the factory high speed
setting can be dangerous.
If you think
the engine-governed
high speed needs
adjusting, contact a Sears or other
qualified service center, which has proper
equipment
and experience
to make any
necessary adjustments.
Immediately
prepare your lawn mower for storage at the end of the season or if the unit
will not be used for 30 days or more.
LAWN
MOWER
When lawn mower is to be stored for a
period of time, clean it thoroughly,
remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See
"CLEANING"
in the Maintenance
sec-
tion of this manual).
2.
Lubricate as shown in the Maintenance
section of this manual.
3. Be sure that all nuts, bolts, screws, and
pins are securely fastened.
Inspect
moving parts for damage, breakage
and wear.
Replace if necessary.
4. Touch up all rusted or chipped paint
surfaces; sand lightly before painting.
Operator
MOWING
POSITION
control bar
FOLD
FORWARD
FOR
STORAGE
_
///
////
iiii
I
////
/%
Upper
handle
Handle
knob
Lower handle
HANDLE
You can fold your lawn mower handle for
storage.
1. Loosen the two (2) handle knobs on
sides of the upper handle and allow
handle to fold down to the rear.
2.
Remove the two (2) handle knobs and
carriage bolts on sides of the lower
handle and pivot entire handle as-
sembly forward and allow it to rest on
mower.
3. Reinstall knobs and carriage bolts to
lower handle or handle brackets for
safe keeping.
• When setting up your handle from the
storage position, the lower handle will
require manually locking into the mow-
ing position.
IMPORTANT:
When folding the handle
for storage or transportation,
be sure to
fold the handle as shown or you may dam-
age the control cables.
17
\\
)
/
Bolt
Handle
bracket

Publicidad

loading