Kenwood TK-250 Manual De Instrucciones página 10

DISPLAY
PO oe ©) °
LO SCN | BUSY'||
TA MON- CALL
if
~
+
ZS Le
Tye o 9 © 4)
@ a
@ @
Appears when a Priority channel is being used.
(2) LO
Appears when the Transmit Low Power function is
selected. When this indicator is not visible, the power
that was set for each channel (High, Medium, or Low)
via the Field Programming Unit (FPU) is used.
@ TA
Appears when the Talk Around function is activated.
@ A
Appears when the selected channel is assigned to the
scan list.
6
6) SCN
Appears when the Scan function is activated.
© MON
Appears when the monitor function is activated.
® BUSY
Appears when a carrier is present on the selected
channel.
CALL
Blinks when the correct signal is received for the
current channel while the DTMF Decode function or the
2-Tone Decode function is activated.
® 88
Displays the selected Group number from 1 to 10.
The 4-character alphanumeric display uses the middle
2 digits to show the channel number. The dealer can
program 4-character channel names to replace the
channel numbers. One channel name can be
substituted for each channel number.
Appear when the scrambler function is activated.
KENWOOD does not offer a scrambler unit as an
accessory, however, a commercially available unit can
be installed.