Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
4
Installing the spout assembly
□
Install the spout assembly (A) onto the
connector (E). Be sure the spout assembly (A)
is resting rmly on the deck.
□
Push down on spout assembly (A) and tighten
set screw (B) with the Hex wrench
(Hex: 3.2mm, C).
6
Installing the valve bodies
NOTE: The hot end valve is identi ed with a label.
□
From underneath the deck, insert the cold end
valve (S) with the rubber washer (T), metal
washer (U) and mounting nut (V) through
the hole on the right (cold) side.
□
From above, thread the ange (Q) onto the
valve body (S).
□
Tighten the mounting nut (V) using a basin
wrench, so that the ange (Q) sits ush against
the nished deck surface.
□
Repeat this procedure for the hot end valve (R)
on the left (hot) side.
A
C
B
E
5
Removing the mounting kits
□
Remove the protective caps (P). Loosen the
anges (Q) from the valve bodys (R & S). Adjust
the rubber washers (T), metal washers (U) and
mounting nuts (V) to the bottom of valve
bodys (R & S).
R
5
Please contact 1-855-HD-GLACIER for further assistance.
P
Q
R
T
U
V
S
T
U
V
HOMEDEPOT.COM
P
Q
S
T
U
V
Q
Publicidad
