Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECT HEADLIGHT
• Connectwireharnessterminalsto
headlight a ssemblylocated undercontrol
panelas shownin the figurebelow.
• Tie headlight c ableto lowerhandleswith
the plasticcabletie suppliedin the parts
bagby threadingthe pointed
ends of the
tie through the square end and pulling
tightlyaround the headlight cable and
handles. See figure below.
NOTE: One side of the plastic tie has small
notches in it, while the other side is smooth.
The notched side must be on the inside of
the loop which is formed when the ends are
put together.
Wire Harness
Terminat
Headlight
J
Cable
Wire
Harness
Termir
Cable Tie
Lower
Handle
CONNECT
REMOTE
CHUTE
• Push remote chute control lever into
Up" /'_
position.
"Chute Deflector
- Feed "Z" fitting through hole in remote
chute bracket as shown in figure below.
• Snap remote chute control cable into
remote chute bracket, see figure below.
Remote
Chute
Remote Chute
Control
Bracket
Bracket
Chute
Control Cable
o Connect "Z" fitting into remote chute
control bracket as shown in figure below.
• Push remote chute contro! lever into
"Chute Deflector Down" '=_ position.
° Cut tie strap on chute deflector as shown
in figure below.
Chute
Deflector
INSTALL
MID-CHUTE
ROD
(set aside earlier)
• Carefully remove cotter pin and clevis
pin from universal joint in the upper crank
rod as shown in first figure below.
NOTE; If this removes the universal joint
and universal joint pin, Place universal joint
into yoke of upper crank rod lining up large
holes. Insert universal joint pin (ensure
opening in universal joint pin is in line with
small openings in universal joint),
Upper
Clevis Pin
Rod
Universal Joint
.,.__Joint
Pin
CotterPin
° Place yoke of open end of mid-crank rod
around universal joint in upper crank rod.
Insert clevis pin through assembly and
secure with cotter pin. Spread ends of
cotter pin to lock in place. See figure
below.
Mid-Crank
pper Crank
Rod
Rod
Publicidad
