Descargar Imprimir esta página

Walter MINI 4.5 Instrucciones De Manejo página 14

Publicidad

Idiomas disponibles

Idiomas disponibles

En ENGLISH
Switching on: Switch the machine on as described above. Now slide the trigger switch (9) forwards again
and release in the front position to lock the trigger switch (9) (continuous operation).
Switching off: Push the trigger switch (9) upwards and release.
7.3
Working Directions
Grinding and sanding operations:
Press down the machine evenly on the surface and move back and forth so that the surface of the workpiece
does not become too hot. Rough grinding: position the machine at an angle of 30° - 40° for the best working
results.
Abrasive cutting-off operations:
Always work against the run of the disc (see illustration). Otherwise there is the danger of the
machine kicking back from the cut out of control. Guide the machine evenly at a speed suitable
for the material being processed. Do not tilt, apply excessive force or sway from side to side.
Wire brushing:
Press down the machine evenly.
7.4
Rotate gear housing
See illustration D on page 3.
- Disconnect from the power supply.
- Unscrew the fastening screw (a) of the lever (15). Remove the screw, lever (with its sheet metal part) and put
aside.
- Unscrew the 4 gear housing screws (b). CAUTION! Do not remove the gear housing!
- Turn the gear housing to the desired position without removing it.
- Screw in the 4 gear housing screws (b) in the available threads! Tightening torque=3.0Nm +/- 0.3Nm.
- Slide the spring that pushes the lever in position to the side and re-insert the lever (15) (with its sheet metal
part), and fix with the fastening screw (a). Tightening torque = 5.0 Nm +/- 0.5 Nm. Check the
lever for correct function: it has to be under spring tension.
8. Cleaning
It is possible that particles deposit inside the power tool during operation. This impairs the cooling of the power
tool. Conductive build-up can impair the protective insulation of the power tool and cause electrical hazards.
The power tool should be cleaned regularly, often and thoroughly through all front and rear air vents using a
vacuum cleaner. Prior to this operation, separate the power tool from the power source and wear protective
glasses and dust mask.
9. Troubleshooting
Machines with DIALSPEED and DYNAMAX electronics:
The electronic signal display lights up and the load speed decreases. (7) There is too much load
on the machine! Run the machine in idling until the electronics signal indicator switches off.
9
14

Publicidad

loading