Publicidad
Idiomas disponibles
Idiomas disponibles
Do not operate the battery charger on easily inflammable surfaces (e. g., paper,
textiles, etc.) or surroundings. The heating of the battery charger during the charging
process can pose a fire hazard.
VIBRATION AND NOISE INFORMATION
Vibration and noise level
The vibration and noise emission level stated in this instruction manual has been
measured in accordance with a standardised test in EN 62841. It may be used to compare
one tool with another and as a preliminary assessment of exposure to vibration and
noise when using the tool for the applications mentioned in this manual. However, using
the tool for different applications, or with different or poorly maintained accessories, may
significantly increase the exposure level.
An estimation of the level of exposure to vibration and noise should also take into
account the times when the tool is switched off or when it is running but not being
used, as this may significantly reduce the exposure level over the total working period.
Protect yourself against the effects of vibration and noise by maintaining the tool and its
accessories, keeping your hands warm and organising your work.
Other risks
Even when the power tool is used as prescribed, it is not possible to eliminate all
other risk factors. The following hazards may arise in connection with the power
tool's construction and design:
Damage to lungs if an effective dust mask is not worn.
Damage to hearing if effective hearing protection is not worn.
Damages to health resulting from vibrations if the power tool is being used over
longer period of time or not properly handled and maintained.
WARNING! This power tool produces an electromagnetic field during
operation. Under some circumstances, this field may interfere with active or
passive medical implants. To reduce the risk of serious or fatal injury, we
recommend persons with medical implants to consult their physician and the
medical implant manufacturer before operating this machine.
ASSEMBLY
Before any work on the machine (e.g. maintenance, tool change, etc.) as well as during
transport and storage, set rotational direction switch to the centre position. Unintentional
actuation of the trigger can lead to injuries.
10
Publicidad
