Publicidad
Idiomas disponibles
Idiomas disponibles
Charging the screwdriver/drill
First read the safety instructions and then follow the charging instructions.
Connect USB-C cable end to USB-C port on the battery pack (Pic. 2) (A). Connect the other
USB cable end to a USB-charger or USB-outlet that can provide sufficient power to charge
the screwdriver/drill. When the battery pack is connected to the power supply, the diodes
on the back of the battery pack light up to indicate the charging status:
- Pulsating light - charging in progress
- Steady light for two minutes/no light - charging completed
Make sure that there are no knots or sharp bends in the cable. After the battery pack
is fully charged and the battery pack remains connected to the power supply, the
diodes will stay lit for two minutes and then turn off. When the charging is completed,
disconnect the charging cable and then slide the battery pack into the holder of the
screwdriver/drill. The screwdriver/drill is now ready to use. When the screwdriver/drill is
not in use, disconnect the battery pack from the screwdriver/drill and store it in a suitable
place. Under normal conditions of use the screwdriver can be recharged several hundred
times.
ATTENTION! The recharging process generates heat in the battery. It is not advisable to
recharge the battery in temperatures below freezing. The battery will gradually lose its
charge over a period of time, even if the tool is not used.
Checking the power status on battery pack
You can check the battery pack's power status by briefly pushing on the button located
on the back of the battery pack. The diodes will light up to indicate the remaining power
status:
- 3 diodes light up - full charge
- 2 diodes light up - medium charge
- 1 diode lights up - low charge
Shortly after, the diodes will turn off.
Note: The battery that is supplied with the screwdriver/drill has been charged for test
purposes only and must be fully recharged before first time use.
TRIXIG screwdriver/drill and TRIXIG battery pack have been designed to be used together.
NEVER use this battery pack to power cordless tools from other manufacturers.
The lithium-ion battery is protected against deep discharging by the "Electronic Cell
Protection (ECP)". When the battery is empty, the machine is switched off by means of a
protective circuit: The inserted tool no longer rotates.
WARNING Do not continue to press the On/Off switch after the machine has
been automatically switched off. The battery can be damaged.
WARNING! Recharge the battery on a non-flammable surface. Do not recharge
the battery for more than eight hours.
11
Publicidad
