Publicidad
Idiomas disponibles
Idiomas disponibles
machine can still work for a few cycles below this minimum level but
it is advisable to top up to prevent it from emptying completely. In
this case a filling procedure is available (also useful for the first top
up). To activate the filling procedure move your hand quickly 5 times
in 2 seconds under the photocell so that it is activated. The last time
(the sixth) keep it under the photocell and the dispenser will activate
in continuous mode. When the Gel starts to come out remove your
hand. At this point the dispenser is ready for ordinary operation.
2.5 l. tank top up
ACCESS CONTROL SYSTEMS I/O INTERFACING
The dispenser has a programmed output for managing a turnstile or
semaphore or any device used for access control. The output is
activated for a second with each dispensing cycle and can be used
to unlock a turnstile, other uses can be implemented through a
firmware update procedure. The connector is located in the lower
dispenser panel. Contact the technical assistance service if needed.
L-LC202.00-BM
Min. level indication led
Out + 24V (2mA-250mA)
Gnd
EN
5. DISPENSER CLEANING AND MAINTENANCE
Make sure the machine is off; the on/off button must be off.
Unplug it.
Clean the body and the accessories with a damp cloth and then dry
with a dry, non-abrasive cloth. Food grade detergents should not be
used.
Do not spray the dispenser with a lot of water or partly or completely
submerge it.
6. FAULTS AND REPAIRS
Do not use the dispenser if the cable or plug are damaged or if it
shows signs of poor operation or has been damaged. Contact your
representative right away for the correct testing operations and/or
replacement of the dispenser. If the cable is damaged it must be
changed by the manufacturer or his assistance service.
7. DECOMMISSIONING AND DISPOSAL
At the end of its service life, this dispenser must be decommissioned
and disposed of by delivering it to the local recycling system
according to current legal provisions, which must be scrupulously
followed. Consequently, the owner needs to find the local system that
collects electrical and electronic products and follow its instructions.
Illegal disposal of this product in normal household waste may create
serious damage to the environment and human health and is subject
to punishment by the local administrative authority.
For European Union countries, before scrapping, check
the machine serial number label: if it has the symbol
shown on the side it means its disposal is governed by
European directive 2012/19/EU on Waste Electrical and
Electronic Equipment, (WAEE) and current national laws.
Thus the provisions of the local collection system for
electrical and electronic products must be scrupulously
followed.
6 / 12
Publicidad
