Publicidad
Idiomas disponibles
Idiomas disponibles
1. Before replacing tank cover, refer to Dry Pick Up or Wet Pick Up Operation
in user manual to ensure you have the proper filters installed for your cleaning
operation.
2. Replace tank cover, and apply pressure with thumb to each latch until it snaps
tightly into place. Make certain all lid latches are clamped securely.
3. Insert machine hose end with locking-nut into inlet of tank. Turn locking nut to
tighten. Do not over tighten.
4. Attach the extension wands to the accessory end of the hose. Twist slightly to
tighten the connection. FIGURE 1.
5. Attach one of the cleaning accessories (depending on your cleaning
requirements) on the extension wands. Twist slightly to tighten the
connection. FIGURE 1.
6. Plug the cord into the wall outlet. Your cleaner is ready for use.
I= ON, 0 = OFF.
NOTE: Many more useful tools are available at your local dealer or
channellockproducts.com.
FILTER INSTALLATION AND CLEANING
1
2
8
7
13
DRY PICK UP OPERATION
NOTE: Never use the vacuum for dry pick up without a dry use filter installed on
the lid cage. Using the vacuum without a filter will cause dust to discharge from
blower port and cause damage to motor.
6
GENERAL SET UP
1
3
4
9
10
5
6
11
12
Publicidad
