Wellell Optima Turn Manual De Instrucciones página 18

Optima Turn/English
Appendix A: EMC Information
Guidance and Manufacturer's Declaration- Electromagnetic
Emissions:
This device is intended for use in the electromagnetic environment specified below. The user of
this device should make sure it is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC61000-3-2
Voltage fluctuations /
Flicker emissions
IEC61000-3-3
Warning:
1. The device should not be used adjacent to or stacked with other equipment. If adjacent or
stacked use is necessary, the device should be observed to verify normal operation in the
configuration in which it will be used.
2. Use of accessories, transducers and cables other than those specified or provided by
the manufacturer of this equipment could result in increased electromagnetic emissions
or decreased electromagnetic immunity of this equipment and result in improper
operation.
3. Portable RF communications equipment (including peripherals such as antenna cables
and external antennas) should be used no closer than 30 cm (12 inches) to any part of the
Pump, including cables specified by the manufacturer. Otherwise, degradation of the
performance of this equipment could result.
Compliance Electromagnetic Environment-Guidance
Group1 The device uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic
equipment
Class B
The device is suitable for use in all establishments,
Class A including domestic establishments and those directly
connected to the public low-voltage power supply
network
Complies
15