Braun ThermoScan 3 Manual página 11

Store the thermometer and hygienic lens filters in a dry
location free from dust and contamination and away from
direct sunlight.
Additional hygienic lens filters (LF 40) are available at most
stores selling the Braun ThermoScan® 3 Ear thermometer.
Troubleshooting
Situation
No hygienic lens
filter is attached.
Measurement
before device
stabilization.
Situation
Ambient
temperature is not
within the allowed
operating range
( 50–104 °F or
10–40 °C).
HI = too high
LO = too low
Temperature taken
is not within typical
human temperature
range (93.2–108 °F
or 34–42.2 °C )
System error
Battery is low.
Battery is too low.
Device cannot be
powered on to the
ready state.
Solution
Attach new, clean, hygienic
lens filter.
Wait until all the icons stop
flashing.
Solution
Allow the thermometer to remain
for 30 minutes in a room where
the temperature is between
50 and 104 °F or 10 and 40 °C.
Make sure the probe tip and lens
are clean and a new, clean,
hygienic lens filter is attached.
Make sure the thermometer is
properly inserted. Then, take a
new temperature.
Reset the thermometer
by removing the battery and then
replacing it again, wait 1 minute,
then turn on again.
Please contact your authorized
Service Center (See Guarantee
Card).
Insert new battery.
Insert new battery.
English
9