Publicidad
Idiomas disponibles
Idiomas disponibles
4. Insert both ends ofyour
line
through the proper holes in the
side of the cutting head.
!
Positioning
5. Pull the line and make sure the
line is against the hub and ex-
tended full through the positioning
tunnels,
Line against
Tunnel "
6. Correctly installed line will be the
same length on both ends
BLADE REPLACEMENT
Refer to the ASSEMBLY section for
blade replacement
instructions and
illustrations.
CARBURETOR
ADJUSTMENT
_WARNING:
Keep ethers away
when making idle speed adjustments.
The trimmer head or blade will be
spinning during most of this proce-
dure. Wear your protective equipment
and observe all safety precautions.
After making adjustments,
the trimmer
head or blade must not move/spin at
idle speed.
The carburetor
has been carefully set
at the factory. Adjustments
may be
necessary if you notice any of the fol-
lowing conditions:
• Engine will not idle when the throttle is
released.
• The trimmer head or blade moves/
spins at idle.
Make adjustments with the unit sup-
ported so the cutting attachment
is off
the ground and will not make contact
with any object.
Hold the unit by hand
while running and making adjust-
ments. Keep all parts of your body
away from the cutting attachment
and
muffler.
Idle Speed Adjustment
Allow engine to idle. Adjust speed until
engine runs without trimmer head or
blade moving or spinning (idle too
fast) or engine stalling (idle speed too
slow).
• Turn idle speed screw clockwise to
increase engine speed if engine
stalls or dies.
• Turn idle speed screw counterclock-
wise to decrease engine speed if
trimmer head or blade moves or
spins at idle.
i_ll WARNING:
Recheck the idle
speed after each adjustment.
The
trimmer head or blade must not move
or spin at idle speed to avoid serious
injury to the operator or others.
Air Filter
Cover
_
Idle S
Screw
If you require further assistance or are
unsure about performing this proce-
dure, contact your Sears Service Cen-
ter or call our customer assistance
help line at 1-800-235-5878.
15
Publicidad
