Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: I tmay benecessary torelo-
cate theshoulder strap clamp onthe
shaft f orproper balancing ofunit.
TO RELOCATE SHOULDER STRAP
CLAMP:
1. Loosen and remove both clamp
screws.
2. Place the upper shoulder strap
clamp over the tube,
3. Position the lower shoulder strap
clamp under the tube and align the
upper and lower clamp screw
holes.
!
30 inches
! Clamp
7
Lower Shoulde
!
Strap Clamp
4. Insert two screws into the screw
holes.
5. Secure shoulder strap clamp by
tightening screws with a hex
wrench.
HARNESS
ADJUSTMENT
FOR BALANCE
6 inches
=
be{ow
4 - 12
waist
inches
above
.1_'_
round
CONFIGURING
YOUR UNIT
You can configure your unit using a cut_
ring head for grass and light weeds, or
a weed blade for cutting grass, weeds,
and brush up to 1/2 inch in diameter. To
assemble your unit, go to the section for
the desired configuration and follow the
instructions.
ASSEMBLY
INFORMATION
-
TRIMMER HEAD
NOTE: Remove the blade and metal
shield before attaching the plastic shield
and trimmer head, To remove blade,
align hole in the dust cup with the hole
in the side of the gearbox by rotating
the dust cup, Insert a small screwdriv-
er into aligned holes. This will keep
the shaft from turning while loosening
the blade nut, Remove blade nut by
turning clockwise. Remove the screw-
driver, Remove beth washers and
blade, To remove metal shield, loosen
and remove the four mounting screws,
See ATTACHINGTHE METAL SHIELD and
iNSTALLATIONOF THE METAL BLADE for
illustrations. Be sure to store all parts
and instructions for future use.
INSTALLATION
OF THE CUTTING
HEAD (if not already installed)
NOTE: Before installing the trimmer
head, make sure the dust cup and re_
taining washer are positioned on the
shaft of the gearbox.
The retaining
washer must be positioned with the
raised section toward the gearbox.
1. Align hole in the dust cup with the
hole in the side of the gearbox by
rotating the dust cup,
2. Insert a small screwdriver
into
aligned holes. This will keep the
shaft from turning while tightening
trimmer head.
6
Publicidad
