Oclean W10 Instrucciones página 12

Battery indicator light
Red light flashing:
low battery alert;
White light breathing:
charging state;
White light normally on:
the battery is fully
charged; the oral
irrigator is in working
condition
Powerful Normal Mode
Standard Normal Mode
Sensitive Normal Mode
Impulse Mode
Point Shooting Mode
Type-C charging interface
Open the lid, insert
the USB charging
cable, and charge.
Instruction for use
Install the nozzle
Insert the nozzle into the
main body of the oral
irrigator.
Switching button
Perform a short press on
the "mode button" to
switch modes.
Preparation before use
Before use, please bend down slightly and extend the
nozzle into your mouth, aim at the teeth, gaps among teeth
or gums to ensure that the water flow is perpendicular to
irrigation positions, and at the same time, open your mouth
slightly so that the irrigation water can flow out of your
mouth.
Warm tips:
The first time you use the oral irrigator, you may experience
itching or slight gum bleeding. This phenomenon usually
stops within 1 to 2 weeks, if it exceeds 2 weeks, it may
indicate that your gums are abnormal, please stop using the
oral irrigator and consult the dentist.
Nozzle assembly button
Press the button and
insert the nozzle into
the main body of the
oral irrigator. Press the
button again, and take
out the nozzle from the
main body of the oral
irrigator.
Power button
Perform a short press
on the power button
to start the oral
irrigator, the white
light is normally on,
and perform a short
press on the power
button again to shut
down.
Mode button
Inject water into the
water compartment
Lid and inject clean water,
the water temperature is
appropriate to feel
comfortable(recommend-
ed not to exceed 40°C),
then close the lid, and the
installation is completed.
10