kooa HPC2206 Manual Del Usuario página 17

‚ Ensure you can easily access the power
outlet so that you can quickly unplug the
USB charger if necessary.
‚ Fully unwind the USB charging cable before
charging. Ensure the charging cable cannot be
damaged by sharp edges or hot objects.
‚ Disconnect the USB charger from the power
outlet:
– when not in use,
– when the battery is fully charged,
– when a noticeable fault occurs during
charging (e.g. smoke, odour, etc.),
– before cleaning, maintaining or packing
away the device,
– during a thunderstorm.
When doing so, always pull on the charger, not
on the cable.
‚ The LED is permanently installed and cannot
be replaced or repaired.
‚ Do not modify the device. The damaged unit
must only be repaired in a specialist workshop
to avoid hazards. Observe the warranty terms
and conditions.
‚ Visually inspect the device before each use.
If the device is damaged, have it repaired in a
specialist workshop before using it again.
RISK of injuries
‚ Never touch the grinding head when the
device is switched on.
‚ You must switch off the device when...
... you lay it aside to charge it or make a short
break during grinding, or
... you are about to lubricate it.
BEWARE of material damage
‚ The battery in the unit is not replaceable.
‚ Do not cover the USB charger and device
during charging to avoid heat build-up.
17