Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Timing button : Each press increase timer by 0.5 hour , up to 7.5 hours .The
LCD indicates the time remaining . The machine automatically shuts down when
timer reaches 0 .
Cooling button : Press the "COOL" button to cool.
Warm button: Press the "WARM" button to heat.
Wind button : Press the "WIND" button to change wind bearing 90℃ angle .
button : Start or turns off the machine .
Battery Installation :
1. Open the battery board of the remote control .
2. Insert 2 AAA batteries .
3. Close the cover .
NOTES :
The polarity of batteries must match the indicator in the remote control .
Please do not mix new and old batteries in remote control .
If the remote control is not used for a long time , take batteries out to avoid
corrosion .
CLEAN AND REPLACE FILTER
A filter is already assembled before delivery from factory . But the filter should
be cleaned or replaced after a period time . Normally , filter should be replaced
every year . If filter is damaged , replace the filter immediately . (Please contact
your local distributor ) .
Cleaning procedure is described below :
1. Hold the machine with your left hand , and pull the filter frame out with your
right hand .
2. Take the filter out of the filter frame . Tap the filter gently to clean . If the filter
is very dirty , dip it into natural detergent solution . Gently wash the filter ,
and then rise it thoroughly with water .
3. Put the cleaned or new filter back into the filter frame in proper position .
Then gently insert filter frame back to machine .
IMPORTANT NOTICES:
1) Do not insert hand or other thing into the air outlet when machine is operating.
2) Keep the machine at least 0.3 meter away from wall.
3) After filling the water tank, avoid moving the machine since the water may
spill. Instead, push it gently with the help of the wheels at the bottom.
4) The power plug should be properly grounded.
5) Because negative ions are generated at the wind outlet, you may sense
some static if you touch the wind outlet. This is normal and it has no danger.
6) The wind outlet has a label "Do not Cover". Don't block the wind outlet with
cloth or other objects.
7) Clean the filter once every 20-30 days, depending on your room condition. If
filter is damaged, it should be replaced immediately.
8) Please refer to the instruction. Any changes will not be informed.
9) If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
IMPORTADO POR ECOGEST TRADE S.L.
C.I.F.: B-97346225
Publicidad
Tabla de contenido
