Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
1. Route power cord through cord hole edge protector through the semi-circle hole in the right-most panel of the sub-
base.
2. Plug the cord into the receptacle.
3. Secure all covers on the sub-base.
Note: A junction box and chaseway is NOT required for this Hotpoint PTAC installation as the cord is equipped wiith
an LCDI power cord. However, if they are desired for a cleaner installation, these GEA service parts may be ordered
separately:
• Junction Box: WP76X29134
• Chaseway: WP76X29133
31-5000843 Rev. 0 08-23 GEA
3
Publicidad
