Airthings RENEW Manual De Instrucciones página 8

USING THE CONTROL PANEL
The panel comprises a row of indicator lights next to control buttons for
common operations. Additional operations can be activated by using a
combination of buttons which are also described here.
Silent mode
Runs on the lowest
speed for 8 hours with
panel lights dimmed.
Child lock indicator
Press Auto and Boost
together for 3 seconds
to turn child lock on
or off.
Air quality indicator
Indicates the room's
current air quality in
terms of the PM level.
Red = POOR
(Over 25 µg/m )
3
Yellow = FAIR
(10 µg/m
to 25 µg/m )
3 3
Green = GOOD
(Less than 10 µg/m )
3
Filter change indicator
Glows when it's time
to replace the filters.
Check the Airthings
app for easy ordering.
EN
14
Fan speed controls
For manual operation
of the 5 speeds.
Boost mode
Runs on top speed
for 1 hour.
Auto mode
Set & forget. Adjusts fan
speed based on current
air quality.
Standby
Turns the purifier
function on or off. When
off, the air quality sensor
continues to operate.
WiFi status
Glows steady when
connected to Internet
via WiFi. Is off if not
connected to WiFi.
Blinks if connected to
WiFi but there is no
Internet connection.
Here are the additional operations you can perform using the onboard
control panel:
Reset the filter Do this right after changing the filters. Press and hold
change indicator the Silent mode button for 5 seconds. This resets the
filter algorithm and turns off the filter change indicator
light.
Turn off button Press the Boost mode button for 5 seconds to turn off
beeps the beeps when the buttons are pressed. Do the same
to turn the beeps back on.
Dim the panel's The LED lights are always dimmed when you activate
LED lights Silent mode. You can manually dim lights for ALL modes
by pressing the Auto mode button for 5 seconds. Do the
same to turn the lights back on.
Reset the unit to Press and hold both the + and - buttons for 10 seconds
factory settings to factory reset the device. When you factory reset the
device all WiFi connections are erased and the device
is ready to be paired to a new account in the app. The
device will continue to show in your app unless you
delete it, but you can no longer see new PM data or
access smart functionality.
EN
15