Publicidad
Idiomas disponibles
Idiomas disponibles
NOTICE:
When disconnecting the plug and
socket, do not hold the cords but hold the plug
and socket. Otherwise, the cords may be damaged
and cause a malfunction of the unit.
NOTE: The plug and socket are disconnected if a
certain load is applied.
5.
Install the adapters to the tool or machine in the
same way as the battery cartridge.
1
Fig.24
► 1. Adapter
•
For 36 V (18 V x 2) battery-powered tool or
machine, use the adapters for 36 V (18 V x 2).
•
For 36 V - 40 V max battery-powered tool or
machine, use the adapter for 36 V - 40 V max.
•
For direct connection type tool or machine,
no adapter is required.
NOTE: The direction of the cord of the adapter can be
changed in the range of approximately 180 degrees.
6.
Press the power button to turn the power on. To
turn the power off, press the power button for a few
seconds.
Fig.25
► 1. Power button
NOTICE:
When installing adapters to the tool or
machine, be sure to install the adapter equipped
with 2 cords to the location shown in the figure.
If you install the adapters incorrectly, the adapter
equipped with 2 cords cannot be inserted all the
way. In this case, do not insert the adapter forci-
bly. Otherwise, the tool or machine may be damaged.
Fig.26
► 1. Adapter with 2 cords
1
Fig.27
► 1. Adapter with 2 cords
13 ENGLISH
1
1
Publicidad
