Publicidad
Idiomas disponibles
Idiomas disponibles
Putting on the unit
CAUTION:
Before putting on or putting off the
unit, be sure to disconnect the tool or machine
from the unit.
CAUTION:
When adjusting the position of the
base plate, be sure to lay down the unit so that the
battery faces downward as shown in the figure.
Before putting on the unit, adjust the position of the
base plate to suit your body by referring to the section
for assembly in this instruction manual.
NOTE: If it is difficult to slide the base plate, lift up the
bottom of battery slightly so that the stand does not
touch the ground, and then slide the base plate.
Fig.28
1.
Put on the unit.
Fig.29
2.
Adjust the length of the shoulder harness so that
the waist belt is at your waist.
Fig.30
Make sure that the waist belt is in the recommended
position as shown in the figure. If the waist belt is above
or below the recommended position, it is difficult to work
comfortably.
•
The waist belt is in the recommended position.
Fig.31
•
The waist belt is above the recommended
position.
Fig.32
14 ENGLISH
Publicidad
