Publicidad
Idiomas disponibles
Idiomas disponibles
5. Respect the polarity of the amplifier termi-
nals with that of the speakers as shown in
the diagram opposite (generally red with
red and black with black). Installation with
the wrong polarity will result in a significant
drop in performance.
7. Once the connections are completed, check that the cables have been completely inser-
ted and that there are no metal parts of the respective conductors that put the two terminals
in contact: this circumstance will result in a strong compromise in performance and a high
risk of damaging the amplifier. (Short circuit).
Cleaning and maintenance
The speakers do not require any maintenance. For their cleaning, avoid too aggressive or
abrasive substances: use a damp cloth gently rubbed on the surfaces after disconnecting the
signal connection, avoiding in any way contact with the speaker cones and domes: any
accumulation of dust on the latter they can be removed with extreme delicacy using a brush
or a soft bristle toothbrush, considering that any deformation will inevitably affect the acoustic
performance.
Wait for the speakers to dry completely before reconnecting and putting them back into
service.
Product warranty
Melchioni S.p.A., based in Milan (Italy), via Colletta 37, recognizes a conventional guarantee
on the product for a period of two years from the date of the first purchase by the consumer.
This guarantee does not affect the validity of the legislation in force concerning consumer
goods (Legislative Decree 6 September 2005 n. 206 art. 128 and following), of which the
consumer remains the owner. This guarantee applies to the entire territory of the European
Union.
The components or parts that are found to be defective for ascertained manufacturing
causes will be repaired or replaced free of charge through the dealer, during the above
warranty period. Melchioni S.p.A. reserves the right to make a complete replacement of the
device, if repairability is impossible or excessively expensive, with another device of similar
6. Unscrew the cylindrical clamps until the circular hole is
completely uncovered, then strip each of the two poles of
the signal cable coming from the amplifier for a length of
1.5 - 2 cm, pass the stripped part through the hole and
tighten with decision, but without exceeding, the clamps.
Alternatively, it is possible to use Ø 4 mm banana
connectors to terminate the wiring, which must be inser-
ted in the appropriate holes at the top of the terminals.
AMPLIFIER
Publicidad
