Descargar Imprimir esta página

Hitachi Hi-Box Manual De Instalación Y Funcionamiento página 7

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
SAFETY SUMMARY
1 SAFETY SUMMARY
!
D A N G E R
Adhere to the electrical standards in effect, as well as the following
points:
!
C A U T I O N
Avoid falls and collisions.
Never attempt to immerse the product in liquid.
Do not use abrasive products or solvents to clean the casing. Its
surface may be cleaned using a soft, dry cloth.
Do not attempt to open the casing.
Do not use this product outside. Do not place the connection wire
outside.
All use or modification of the equipment not anticipated by Johnson
Controls-Hitachi Air Conditioning Products Spain, S.A.U. could lead
to danger in using it.
2 FACTORY SUPPLIED ACCESSORIES
1 x Hi-Box
3 INSTALLATION INFORMATION
The Hi-Box (AHP-SMB-01) has to be used together with
another Gateway to control and programme scenarios for the
installations:
• ATW-TAG-02, to control YUTAKI units
• SPX-TAG01, to control HITACHI RAC units
?
N O T E
The product can be switched off completely by disconnecting the power
plug.
!
C A U T I O N
The Ethernet interface must never be directly connected to a
telephone socket.
4 HI-BOX INSTALLATION
4.1 PREREQUISITES
• An Internet connection, with an ADSL box equipped with
an Ethernet port is needed for the installation of the Hi-Box
device.
• For the activation of the Hi-Box a PIN code will be requested
1
PMML0370A REV.0 - 06/2016
Use only the cables and accessories supplied.
Avoid positioning the receiver against or close to any metallic part in
order to avoid any radio transmission drop.
?
N O T E
Place the product in a detachable manner close to the device to be
controlled.
Do not install the Hi-Box where other devices using radio-frequencies
as means of transmission are prohibited (Refer to local standards in
effect).
Do not install the Hi-Box close to devices that may be affected by
radio waves.
Do not install the Hi-Box where persons wearing a pacemaker may
be present.
Do not install the device in a damp environment (for example, a
bathroom).
1 x Adapter
1 x Ethernet cable
Please connect it to your ADSL box or to any other Switch or Ethernet
Hub type network equipment.
Read this installation guide and the safety instructions carefully
before starting installation of this product.
All the instructions given must be followed closely and this guide
must be stored in a safe place throughout the service life of your
product.
Any installation or use outside the specified field of application is
forbidden. This invalidates the warranty and excludes all liability,
as does any failure to comply with the instructions given herein.
in some moment of the installation. Note that this PIN
number can be found on a label affixed to the Hi-Box.
1 x Instruction manual

Publicidad

loading

Este manual también es adecuado para:

Ahp-smb-01