MENIKINI 10SH Manual De Uso Y Mantenimiento página 37

The signal lamp (1-Fig.10) on the
control panel indicates correct
machine feeding.
Turn on the general switch
for pump-heater feeding (3
Fig.10)
Low water level in the tank is
indicated by the no-water si-
gnal lamp (2) and an acoustic
signal.
The signal lamp (2 Fig.10) will turn
on for 2 about seconds and then
will turn off.
When a temperature of about
When a temperature of about
180° is reached along with a
180° is reached (visible on display
pressure value of about 10 bar
4 Fig.4) along with a pressure
(pressure gauge 2 Fig. 8),
the unit is ready to deliver
steam
If water is running low in the
tank, the no-water signal lamp
(2 fi g.4) will start blinking along (2-fig.10)
with an acoustic signal.
On the rear of the machine the
On the rear of the machine the
two tanks for water and deter-
two tanks for water and deter-
gent are easily visible (Fig. 5) only
gent are easily visible. (Fig. 5)
model with detergent.
Fill the tank with running water
as indicated in Fig. 6. When
Fig.10.
the minimum water level is rea-
ched, the signal lamp and the
acoustic signal are turned off.
(2 - Fig. 4) (2-fig.10)
When water refi lls the boiler, the
signal lamp (2 - Fig.4) is turned (2 - fig. 10)
on with no acoustic signal.
DO NOT
English
3
37
Fig. 7
6
4
Fig. 8
Fig. 9
IND0102
7