Deltaco DELC-0002 Manual Del Usuario página 4

ENG
Range
This device can pick up sound 30cm to 300 cm away.
System requirements
Minimum requirements. USB 1.1. Windows: 7/8/8.1/10.
MacOS: 10.4.11
Use
1. Place on a flat surface. For example a table.
2. Connect the USB connector to a USB-A port.
USB audio drivers are automatically installed without
any additional software or drivers.
You can double check if playback and recording drivers
have been successfully installed in sound devices.
For windows:
1. Open sound devices.
2. Under playback and recording tabs, choose and set it
as the default device and set as default communication
device (on playback). Save.
For macOS:
1. Open system preferences, and select sound.
2. Under output and input tabs, select the device.
Note: If you connect or already have connected a
headphone or speaker to a 3.5mm connection that is
not on this microphone, then you should set that device
as default device (playback).
You should also set the device in other programs that
you use. For example in Skype you must set it as de-
fault communications device, microphone and speaker.
3.5mm connection
1. Connect a headphone or speaker to the 3.5 mm
connection.
Mute on and off
1. Touch the button to mute or unmute the microphone.
Green means it unmuted.
Red means it is muted.
Support
More product information can be found at
www.deltaco.eu.
Contact us by e-mail: help@deltaco.eu.
Thank you for choosing Deltaco!
A N O R D I C B R A N D