Publicidad
Idiomas disponibles
Idiomas disponibles
equipment. After this cleaning, you can proceed to
apply a metal protection spray against oxidation and
corrosion, to be applied only to the internal metallic
parts and not to the ceramic ones.
Glass – The glass should only be cleaned when the
appliance is off and completely cold. To do this,
apply the cleaning product to a cloth and clean the
glass, avoiding touching the metal parts so as not to
stain the paintwork or damage them. There is no
need to clean the glass daily, but only when it
obstructs the view of the fire. Generally, following
the steps described for starting the fire and using
the recommended firewood will keep the glass
clean for a long time. It should be noted that it is
possible to carry out a pyrolytic cleaning of the
equipment, including the glass, using dry wood (not
resinous) and making a good fire.
Chimney flue - The chimney flue must be cleaned
by qualified professionals annually during the
summer
season.
maintenance from the company that installed the
equipment. As mentioned, the best time to carry out
this maintenance is during the summer for two
reasons, the first is related to the greater availability
of technicians at this time of year and the second
has to do with the fact that the summer has already
passed. nesting period of birds. Thus, if straw and
other residues have been deposited by the birds
during the chimney cleaning, they will be removed.
See Fig. 8 to 10 - To access the smoke duct through
the interior of the appliance, it will be necessary to
st
remove first (1
) the wood chip, second (2
ceramic side plates that cover the combustion
chamber of the equipment, then (3
metallic support together with the ceramic deflector
and finally, remove the two metallic deflectors (4
Fig. 8
2
nd
– Side plates
You
should
request
rd
) remove the
1
st
– Wood retainer
Fig. 9 and 10
rd
3
– Ceramic flame defletor
At the end of the intervention, the parts must
be assembled in the reverse order of their
removal.
After a prolonged period without using your
appliance, and before starting it again, you must
check if there is no obstruction in the chimney.
this
3.9. SPARE PARTS AND MODIFICATIONS
If you need to replace any part of your Flamebox
equipment, we recommend that you only use
original parts. You can purchase original parts from
your Flamebox installer.
The use of non-original parts, as well as
modifications or alterations to the intended use of
Flamebox
Therefore, all modifications to Flamebox products
that are not previously authorized in writing by
Flamebox, are prohibited.
nd
) the
4.
OPTIONAL EXTRAS
th
).
Flamebox has a set of options that you can
purchase from your Flamebox installer.
Finishing frames - available for the three models,
7, 8 and 10, with a 30mm, 50mm or 80mm rim, with
three or four sides.
Leveling base - Compatible with all Flamebox
inserts, allows you to raise the equipment between
EN
4
th
– Metallic
deflectors
equipment,
voids
the
warranty.
P a g e |
39
Publicidad
