Publicidad
Idiomas disponibles
Idiomas disponibles
2. Using the adapter cable (USB-C - USB) included,
connect the dental water jet to a USB port on your
computer (which must be on) or use a power adapter
with USB output whose voltage is 5 V and is capable of
providing 1 A (in the case of supplying less current the
battery will be slower).
3. Indicators 5, 6 and 7 show the charge level, indicator 7
shows the minimum charge level, indicator 6 shows the
medium charge level and indicator 5 shows the
maximum charge level, during charging the indicator will
flash of the current state of charge. When it finishes
charging, the three indicators will appear constantly
shining.
4. Charging is complete, remove the USB-C connector and
replace the cap that protects the connector 8.
When the battery needs to be recharged?
When you observe pressure decreases drastically or the
dental water jet is turned off before two minutes, it will be a
sign that the battery is discharged and needs to be
recharged as soon as possible.
USE OF DENTAL WATER JET
Filling the water tank
1. With the irrigator turned off, remove the
reservoir 9 by turning it slightly to the right
and pulling it downwards.
2. Fill the tank without exceeding its
maximum
seasonal water, hot water (without its
temperature exceeding 40°C) or mixed
with some type of mouthwash or liquid
mouthwash.
3. Insert the reservoir matching the hole in
the reservoir with the base of the irrigator
and turn it slightly to the left.
capacity,
you
can
6
use
Publicidad
