Publicidad
Idiomas disponibles
Idiomas disponibles
Inserting and removing the nozzle
To insert or remove the nozzle, the dental water jet must
be in off mode.
To insert the nozzle, insert it into the hole on the dental
water jet by the thickest part of the nozzle and then press
it firmly until you hear a "click" indicating that the nozzle is
properly retained.
To remove the nozzle, press the release button 2 and pull
the nozzle.
Using the dental wáter jet
1. Check that the battery is charged.
2. The dental water jet must be turned off, a full tank of
water or solution and the nozzle inserted.
3. Stand over the sink and tilt your head at an angle of
about 45 degrees, then enter the nozzle outlet in the
mouth.
4. Press and hold the on/off button 3 (
and the irrigator will operate in the last selected operating
mode.
5. During cleaning you can change the operating mode
using button 4, by repeatedly pressing this button you
can choose between normal mode (Normal), soft mode
(Soft) or pulse mode (Pulse) (mix normal mode and soft
mode).
6. To remove the irrigator from the mouth to rinse, rest or
finish cleaning, you must turn off the irrigator by pressing
and holding the on/off button 3 (
Never remove the irrigator from the mouth without first
turning it off.
Very important:
• Do not use this device continuously for more than 5
minutes. Remember that the irrigator has a timer that
switches off after 2 minutes.
• To prevent overheating of the pump, never operate
the irrigator without water or solution for a long time.
7
) for one second
) for one second.
Publicidad
