Publicidad
Idiomas disponibles
Idiomas disponibles
Quality
Select the streaming quality for HD or 4K, depending on which Web Presenter model you
are using.
HD
HyperDeck High 45 to 70 Mb/s
HyperDeck Medium 25 to 45 Mb/s
HyperDeck Low 12 to 20 Mb/s
Streaming High 6 to 9 Mb/s
Streaming Medium 4.5 to 7 Mb/s
Streaming Low 3 to 4.5 Mb/s
HD
Streaming High 2.3 to 4.5 Mb/s
Streaming Medium 1.5 to 3 Mb/s
Streaming Low 0.8 to 2 Mb/s
The data rate used by the quality setting will change depending on the video standard Web
Presenter is using. For example, if you select 'streaming high' quality and are running at
1080p24 then it would use the 6 Mb/s data rate.
As you can see in the table, the streaming data rates are lower compared to the HyperDeck
rates. This allows for transmitting data over the internet which typically uses a lower bandwidth
compared to recording data on a disk.
You will notice that each setting has 2 data rates mentioned. The lower number is used for the
lower frame rates of 24p, 25p and 30p, while the higher data rates are used when you are
running higher frame rates of 50p and 60p. It's also worth noting that the default setting for the
streaming quality is Streaming High, as this gives a very high quality streaming channel.
Off and On Air buttons
You can start or stop a live stream by using the 'off' and 'on air' buttons. The 'on air' button
illuminates red when a live stream is in progress.
Remove Imported Settings
To remove all imported streaming settings from your Web Presenter, click the cog icon at the
bottom left of the 'live stream' tab. To confirm your choice click 'remove'.
H.264
HyperDeck High 95 to 220 Mb/s
HyperDeck Medium 66 to 150 Mb/s
HyperDeck Low 38 to 80 Mb/s
Streaming High 34 to 51 Mb/s
Streaming Medium 23 to 35 Mb/s
Streaming Low 13 to 20 Mb/s
H.265
Streaming High 22.5 to 30 Mb/s
Streaming Medium 14 to 20 Mb/s
Streaming Low 8 to 10 Mb/s
4K
4K
Using Web Presenter Setup
17
Publicidad
