Publicidad
Idiomas disponibles
Idiomas disponibles
4. Pull out the water tank. Either clean the water tank or fill the water tank with water.
When filling with water, check that water is lower then "max" and higher than "min".
5. Place the water tank close to the product or halfway inside, so you can reach and
install the water pump. Place the water pump in the bottom. Make sure the plastic
piece goes underneath the plastic hook, so it stays in place. Rotate the plastic thumb
screw 90°. Make sure that the water pump is fixed in position before starting up again.
Displacement of the water pump can cause functional deviations to the fan or air flow.
6. Push in the water tank slowly to not spill water. Use the small plastic handle to lock
the water tank.
Troubleshooting
Problem: The product will not start. Solutions: Check if the power cable is properly
installed. Try another power outlet.
Problem: Air flow is less then normal. Solutions: The filter needs cleaning, or replace-
ment.
Problem: Deviations with the cooling function. Solutions: Check if the water tank has
water. Check that the water pump module is attached and fixed in position.
26
Publicidad
