Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION REQUIREMENTS
Assemble
the necessary
tools and supplies
before beginning
the
washer installation. The parts supplied are in the washer drum.
Tools needed for connecting
the water inlet hoses
•
Pliers (that open to 19/16 in. [39.5 mm])
•
Flashlight (optional)
Tools needed
for installation
•
Open end wrench 17 mm and 13 mm
•
Level
•
Wood block
•
Ruler or measuring tape
Parts supplied
Pedestal
A pedestal may be purchased separately for this washer. This
pedestal will add about 13 in. (33 cm) to the height of your unit
for a total vertical height of approximately
51 in. (130 cm).
CC>
Beaded strap
Transport bolt hole plug (4)
Alternate
Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, please call
1-800-4-MY-HOME
® (1-800-469-4663).
If You Have
You Will Need to Buy
Laundry tub or
Sump pump system (if not already
standpipe taller
available)
than 96 in. (2.4 m)
Overhead sewer
Standard 20 gal. (76 L), 30 in. (76.2 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Floor drain
Siphon break, Part Number 285834;
additional drain hose
Part Number 8318155; and connector
kit, Part Number 285835
Drain hose too
4 ft drain hose extension kit, Part
short
Number 285863
Water faucets
2 longer water fill hoses:
beyond reach of
6 ft (1.8 m) Part Number 76314,
fill hoses
10 ft (3.0 m) Part Number 350008
Optional Pedestal
This pedestal (with storage drawer) is available in three colors:
White - Part Number 42842
Bisque - Part Number 42844
Graphite - Part Number 42846
To order, call your local Sears store. For further information,
please call 1-800-4-MY-HOME
® (1-800-469-4663).
Stack Kit
Are you planning to stack your Kenmore washer and dryer? To do
so, find the stack kit (8541503) in the drum of the matching
Kenmore dryer. Follow instructions
included with the kit.
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer '<walk."
Your washer can he installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. (See "Drain
System.")
Companion appliance location requirements should also be
considered.
Proper installation is your responsibility.
You will need
•
A water heater set to deliver 120°F (49°C) water to the washer.
•
A grounded electrical outlet located within 5 ft (1.5 m) of
where the power cord is attached to the back of the washer.
(See "Electrical
Requirements.")
•
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6
kPa).
•
A level floor with a maximum slope of 1 in. (2.5 cm) under
entire washer. Installing the washer on carpeting is not
recommended.
•
A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures
below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
Publicidad
