Hinkley AZURA Manual Del Usuario página 12

INSTALLING THE LED ASSEMBLY
WARNING: Before starting installation, disconnect the power by
turning off the circuit breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not sufficient to prevent
electric shock.
If you do not plan to install the light kit with your fan at this time,
skip step 1.
While holding the LED assembly under your fan, make the
polarizeplug connections: (Fig. 1)
- White to white
- Black to black
2 Position the notches on the inner edge of the LED assembly
so they match the tabs on the outside of the rim on the
mounting hub. Carefully lift the LED assembly inside the
mounting hub and secure it to the fan by turning the LED
assembly clockwise until snug. (Fig. 1)
Restore power and your light kit is ready for operation.
3
NOTE: The metal light cover included with your fan is an option to
replace the glass for the light in the event that you prefer not to
use the light feature of your fan. The metal light cover is not
necessary for the light operation; it can be saved for later use if
desired. (Fig. 2)
10 | hinkley.com
Wire connectors
Fig. 1
Metal Cover
Fig. 2
Mounting hub
(bottom of motor)
LED Assembly
Mounting hub
(bottom of motor)