Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
INSTALLING THE WINDOW KIT
The instructions below can be used for either a hung window or a
sliding window application.
1. Measure the window opening where the window kit will be
installed. Assemble as many sliders as necessary to fi t the
window. If the window opening is less than the minimum length
of a single slider, use the slider that has the hole in it and cut it
to the correct length. Make sure not to cut the end that has the
hole as this is necessary to attach the exhaust hose adapter. Cut
the adhesive foam seals to the correct length for the window
and attach them to the window sash and frame.
2. Connect the window slider adapter to the window slider by
gently pressing it into the hole in the slider until it clicks into
place.
3. Attach the exhaust hose to the window slider adapter by gently
pressing it into the adapter until it clicks into place.
4. Install the slider kit and hose assembly and close the window to
hold it in place.
5. Attach the air outlet adapter to the back of the appliance by
sliding it down into the channel around the air outlet. Attach the
hose to the air outlet adapter on the back of the appliance by
gently pressing it into the adapter until it clicks into place.
6. Cut the non-adhesive foam seal to match the width of the
window and insert it between the glass and the window frame
to prevent air and insects from getting into the room.
7. Install the security bracket in the window frame with the
provided screws.
Note: Do not over extend or bend the hose as this will impede air
fl ow.
12
1
B
A
A
2
3
4
5
6
7
B
Publicidad
