JENN-AIR JGC9536 Guia Del Usuario página 7

2 3 4
5
1. Left rear surface simmer burner (5,000
BTUs on Hi, 650 BTUs on Lo).
2. Left front surface burner (9,200 BTUs).
3. Center surface burner (I 7,000 BTUs).
4. Right front surface burner (12,500
BTUs).
5. Rightrear surfacesimmer burner (5,000
BTUs on Hi, 650 BTUs on Lo).
MODEL JGC9430
SEALED
BURNERS
The sealed burners are secured to the
cooktop and are not designed to be re-
moved. Since the burners are sealed into
the cooktop, boilovers or spills will not
seep underneath the cooktop.
However, the burners should be cleaned
after each use. The head portion of the
burner has a removable cap that is easily
removed for cleaning.(Seepage8 for clean-
ing directions.)
Burner caps must be correctly placed on
the burner basefor proper operation of the
burner.
H_GH PERE/(,} R/%IAN ( E .....
There is one high speed burner on your
cooktop, located in the center (select mod-
els) or right front position. This burner
offers higher speed cooking that can be
usedto quickly bring water to a boil and for
SIJVU tER BUINEIIS*
These burners are located in the left and
right rear positions (select models) or the
left front position. The simmer burner of-
fers a lower BTU flame for delicate sauces
or melting chocolate.
* BTU ratings wil! vary when usingLPgas.
The grates must be properly positioned
before cooking. To ensure proper posi-
tioning, align bumpers on grate bottom
with the Iocators in the cooktop.
Do not operatethe burnerswithouta
pan on the grate, The grate's porce-
lain finish may chip without a pan to
absorb the heat from the burner
flame,
Although the burner grates are durable,
they will gradually lose their shine and/or
discolor, due to the high temperatures of
the gas flame.
12 34
1. Leffrear surface burner (10,500 BTUs).
2, Leftfrontsurface simmer burner (5,000
BTUs on Hi, 650 BTUs on Lo).
3. Right front surface burner (IS,000
BTUs).
4. Right rear surfaceburner (9,200 BTUs).
• A properly adiusted burner with clean ports will light within a few seconds. If using
natural gas,the flame will be blue with a deeper blue inner cone.
If the burner flame isyellow or is noisy,the air/gasmixture maybe incorrect. Contact
a service technician to adiust. (Adiustments are not covered by the warranty.)
With LP gas, some yellow tips on the flames are acceptable. This is normal and
adiustment isnot necessary.
With some types of gas,you may hear a "popping" sound when the surface burner
is turned off. This is a normal operating sound of the burner.
• To improve cooking efficiency and to prevent possible damageto the cooktop or
pan,the flame must be adjusted so it does not extend beyond the edge of the pan.
6