GE AKM14 Manual Del Propietario Y Instrucciones De Instalación página 11

Installation instructions
[]
[]
iNSTALL THE ACCORDION PANELS
Slide the free end of the accordion panel
into the side panel rails. Slide the panel
down. Be sure to leave enough space to
slip the top and bottom of the frame into
the rails on the cabinet.
NOTE:There is a right and a left accordion
panel. Be sure to use the proper panel for
each side.
[] Slide the left and right accordion panels
into the top and bottom mounting rails.
Top mounting rail Top right
Bottom mounting rail
161 PREPARETHE WINDOW
Cut the window sash seal to the proper
length. Peel off the backing and attach the
seal to the underside of the window sash.
[]
FBq
iNSTALL THE CASE IN THE
WINDOW
Open the window and mark the center of
the window sill.
Carefully slide the case into the window
and center the case. Lower the window
behind the top mounting rail. Pull the
bottom of the case forward so that the
bottom mounting rail is tight against the
back of the window stool. Mount the case
to the window sill using 2 type B screws
for a wood frame or 2 type C screws with
window locking brackets for other types of
windows. Drill pilot holes, if necessary.
type screws
2 B
Stool
F_ iNSTALL THE V-SUPPORTS
For Windows With an Outside Sill:
Assemble theY-support and V-support
bracket with V-support nut and bolt.
Type F bolt
and nut
Le_._ _
Sill angle Right
bracket ----_© _"
V-support
bolt and nut
Position the V-supports
on the case bottom so
that they will be near the
outside wall. Attach a V-
support to each side of the
bottom of the case with
Type F bolts, 2 for each
support.
11