GE AKM14 Manual Del Propietario Y Instrucciones De Instalación página 5

GEAppliances.com
Do Not Operate in FreezingOutdoor Conditions
This cool-only air conditioner was not designed for
fleezing outdoor conditions. It must not be used in
fleezing outdoor conditions.
Remote Control
To ensure proper operation, aim file remote
control at the signal receiver on the air
conditioner
The remote conuol signal has a range of
up to 20 feet.
Make sure nodfing is between file air conditioner
and the remora control that coukt block the
signN.
Make sure batteries are flesh and instaUed
correc@ _ksindicated on the remote control.
Cool Mode
Use the Coolmode at Low, Met/, High or Auto Fan
Speed for cooling. Use the Temperature Increase A /
Decrease W pads to set the desired mmperamre
between 62°F and 86°F in 1 °F increments.
An electronic dlermostat is used to maintain file
room mlnpemlalre.
The compressor will cycle on
and off to keep the room at the set level of comfort.
Set the themlostat at a lower number and the indoor
air will become cooler Set the themlostat at a higher
number and the indoor air will become wam_e_:
NOTE: If theair conditioner i s off andis thentumedon
whileset toa Coolsettingor if tumedfroma fansetting
toa Coolsetting,it maytakeapproximatdg 3 minutes
forthecompressor to startandcoolingtobegin.
Cooling Descriptions
For Normal Cooling--Select the Cool mode and
High or Med fire with a middle set temperature.
For Maximum
Cooling--Select the Cool mode
and High f_m wkh a lower set mmperamre.
For Quieter and Nighttime
Cooling--Select
the
Cool mode and LOWf_m wkh a middle
set
temperature.
Energy Saver Mode
Controls the f_m.
0N--The fire will cycle on and offwith the
compressor This results in wider variations of room
mmpemmre and humidity. Nomm/ly used when the
room is tmoccupied. NOTE: Thefan 1778}/continue t o run
for a short time after the compressorcycles off
OFF--The fire runs all file time, while the
compressor cycles on and off.
Fan Mode
Use die Fan Mode at tow, Med or High fire speed to
provide air circulation and filtering wifllout cooling.
Since fire-only settings do not provide cooling,
a Set mmperamre cannot be enmred. The room
temperature will appear in the display.
NOTE:Auto FanSpeed is available in theFan Mode.
Auto Fan Speed
Set to AutO fire speed
for the f_m speed to
automatically set to file speed needed to provide
optimum comfort settings with the set mmpemmre.
If the room needs more cooling, the f_m speed
will automatically increase. If the room needs less
cooling, the f_m speed will automatical b decrease.
NOTE:Auto FanSpeed is available in theFanMode.
Power Outage Recovery Feature
In file case of a power outage
or interruption,
file
unit will automaficall), restart in file settings last
used a[_er the power is restored. If the De/el/1-24hr
feature
was set, it will resmne
cotmtdown. You me}.
need to set a new dine if desired. 5