Turbo ONE Manual Del Usuario página 6

Change the Gear: Short press
Gear 3 is fast speed mode, Gear 2 is medium speed mode, Gear 1 is slow speed mode.
Acceleration: Gently press the accelerator dial to speed up. (The depth of the press is related to the
gear)
Deceleration: Gently press the deceleration dial to slow down. The harder you press, the greater the
deceleration (the appropriate level of pressure is related to the deceleration, and pushing too hard
cannot increase the braking force and may cause damage to the brake dial)
Total Mileage Clearance: Press
to switch on the scooter, and the total mileage will be cleared.
Failure Sign: When failure occurs, the defective sign on the display there will show accordingly.
Controller Failure
working, usually for the controller failure or controller cable disconnection.
Accelerator Sign : Under normal operating condition, this sign will appear in the display when users
press the accelerator, and the sign will disappear after users release the accelerator.
Brake Sign : Under normal operating condition, the sign will appear in the display when users press
the brake, and the sin will disappear after users release the brake.
3. OPERATION GUIDE
Adjust the nut by tool to fit the disc brake
well. Tighten the part by tool.
Suggestion for using:
Please check if your scooter is correctly assembled before using, there must be a "click" for each
moment of engagement in the vertical locking position of the steering column, and rapid tightening of
the steering column and the folding mechanism. Please note: the brake maybe hot after riding, do not
touch the brake!
the Speed Button and
and button at the same time, then press the power button
: When this sign is showing on the display, it indicates that the controller is not
the Decel Button to switch the gear level.
Adjust the screw to tighten
and fit the part well
6