Quick Reference Operation; Main Specifications - Alan HP 446 Manual Del Usuario

Quick reference
Operation
a. Press the MON button to enable/disable CTCSS/DCS (group mode). SAT
icon is displayed when CTCSS/DCS is enabled.
b. Press and hold the MON button to enable/disable the squelch.
c. Press the CALL and buttons to select scan.
d. Press the CALL and MON buttons to change the scan list. "•" icon is
displayed if the channel is included in the scan list.
e. Press the CALL and buttons to select the priority channel. "P" icon
is displayed.
f. Press the and buttons to lock/unlock the radio. Only the PTT
and MON buttons are enabled when the radio is locked.
g. Turn off the radio, press and hold the
ing the radio on to enable/disable VOX. VOX icon is displayed, PTT
button is disabled.
h. When VOX is enabled press the
tivity. Flashing VOX icon indicates low sensitivity.
i. Press the CALL button to send a paging call to other users using the
same channel and CTCSS/DCS code.
j. Press the and CALL buttons to enable/disable the roger beep.
k. Press the and MON buttons to enable/disable key beeps.
and buttons while turn-
and buttons to set VOX sensi-

Main specifications

ALAN HP 446 extrá meets the requirements of ETS 300 296, the robust
mechanical design is compliant with IEC529 (level IP54).
CTE International has a policy of continuous quality improvement, for this
reason specifications may vary without prior notice.
• Do not service the radio or the batteries by yourself (other than the
routine maintenance described in this handbook). It will immediately void
the warranty and may cause irreparable damage. Always contact your
local dealer for assistance.
Quik reference/Main specifications
11