Publicidad
Idiomas disponibles
Idiomas disponibles
SECTION 4
LOCATION
Possible Installation Locations:
1- Ensure that a clearance of 150 mm (15 cm) is available
between the wall and your cooler so that solely the back of
your cooler faces the wall.
2- When you place it on the corner, leave a clearance of 150
mm (15cm) on its back so that it faces the corner. You may
lean the side on the corner to the wall. (Figure 4)
The most important point for any kind of placement is that
the ventilation of the compressor assembly is not blocked.
Place your product so that it is not inclined in any way and
that it is standing on its legs or castors and then operate it.
(Figure 5)
Your appliance shall operate more efficiently when the
ventilation of the compressor assembly is better.
INSTALLATION
Take off and remove all package materials and lower
wooden pallet of your product before placing it. (It may be
required to lift the cooler to remove the base bracket). For
the weight of the product, please see the technical table.
Install spare parts provided inside your appliance as per the
installation instructions.
Figure 4
Figure 5
17
V.1
Publicidad
