AS Torantriebe URSUS-31 Manual Del Usuario página 21

A) - Position the front and rear supports
1.
The installer should choose the support attachment
system (welding, screwing, molding, etc) in accordance
with the composition of the material to which the
supports are attached (metal, concrete, etc).
Attach the supports on sufficiently robust
structural elements.
IT IS VERY IMPORTANT TO RESPECT THE DIMENSIONS:
If the dimensions are not respected, the piston rod will not
make the whole travel, meaning the mechanical slow
down system will not work.
2.
Carry out the welding with the operator withdrawn
and at a distance. If not, the piston rod may become
damaged from Welding splatter, which could lead to
failures and oil leaks.
B) - Mount the ball bearing joint and the gudgeon
1.
2.
3.
4.
Horizontal pin: ø = 10mm, L = 57.2mm
5.
6.
19