Craftsman 536.772341 Manual Del Usuario página 12

OPERATION
HOW TO USE THE INDEX LEVER
1. Stop the engine and disconnect the
spark plug wire from the spark plug.
2. Loosen the front wheel knob shown in
Figure 10. Slide the front wheel all the
way to the right side.
3. Securely tighten the front wheel knob.
Front Wheel
Knob
NOTE: To prevent the blade from hit-
ting the wheel while trimming, make
sure the front wheel is set in the ex-
treme right position.
4. Disengage the index lever (see
Figure 11). Move the index lever to the
desired position.
5. For edging, set the blade in a vertical
position (see Figure 11). For trimming,
set the blade in a horizontal position (see
Figure 12).
6. Reconnect the spark plug wire to the
spark plug.
Front Wheel
Figure 10
Vertical Position
Index Lever
7. Start the engine.
8. Move the clutch lever to the desired trim-
ming height.
_k WARNING: While the engine is
running, never leave the Edger.
Before you adjust the wheels or
change the blade position, always dis-
engage the cutting blade and stop the
engine.
F_021103C
12
Horizontal Position
Index Lever
Figure 12