TOTALINE Basic 1H/1C Manual De Uso página 13

Operating Manual 570-208
o @
0
0
0
Q
Press the Set button 3 times until Set Program appears. The start time of Period 1 of
the week days (Mon-Fri) will flash.
Press the Up or Down button to set the time.
Press the Set button. The temperature setting for that period wilt flash.
To program the temperature settings for the cooling mode, place the System
switch in Cool. To program the temperature settings for the heating mode, place
the switch in Heat.
Press the Up or Down button to set the temperature.
Press the Set button. The start time of the next period wilt flash.
Repeat steps 2 through 6 for each of the remaining periods.
Once all changes are made, press the Run button to save them and exit.
(The changes will automatically be saved if you do not press any button for 60
seconds.)
Period 1 for the
weekdays is set to 6
a.m. and 70 °F.
To skip a period
(except period 1),
press the Hold button
for 4 sec. while that
period is displayed.
10