Gorenje R2-01 Instrucciones página 3

Remote controller
Remote controller
The remote controller transmits signals to the system.
MODE
1
Press this button to select the operation mode.
SLEEP
3
Used to set or cancel Sleep Mode operation.
SUPER
6
Used to start or stop the fast cooling/heating.
(Fast cooling operates at high fan speed with
16℃(61°F) set temp automatically ; Fast heating
operates at auto fan speed with 30℃ 86°F) set
temp automatically)
ON TIMER
8
Used to set or cancel the timer operation.
QUIET
9
Used to set or cancel Quiet Mode operation.
OFF TIMER
11
Used to set or cancel the timer operation.
SMART
12 (invalid for multi system)
Used to enter fuzzy logic operation directly when
the unit is on .
When the Air conditioner and Remote controller are
in standby, and the mode of remote controller is in
Cooling or Dry, press this button for about 5 seconds
to enter the auto-clean mode and then the indicator
" " will display on LCD . Press SMART or POWER
or MODE button will escape from auto-clean mode,
and then the indicator " " will disappeared, (After
the clean process finish, the air conditioner will return
to Cooling or Dry as preset, while the indicator"
on remote controller will display for about 30 mins)
DIMMER
13
When you press this button, all the display
of indoor unit will be closed. Press any
button to resume display.
Indication symbols on LCD:
Cooling indicator
Auto fan speed
Auto
Lower fan speed
IFEEL
Auto-clean indicator
Note: Each mode and relevant function will be further specified in following pages.
2
1
(
3
6
9
12
13
CLOCK
14
Used to set the current time.
15 ECONOMY
" Used to set or cancel Economy Mode
operation.
+
8℃ HEAT(optional)
2
7
Used to start or stop 8℃ HEAT mode.
Fan only indicator
Dry indicator
Higher fan speed High fan speed
Economy indicator
Quiet indicator
Display temperature
OFF
5
4
5
7
8
10
11
16
19
14
15
Heating indicator
Medium fan speed
Super indicator
ON Display set timer
Display current time
1 1
5
TEMP
2
Used to adjust the room temperature and
the timer, also real time.
POWER
4
The appliance will be started when it is
energized or will be stopped when it is
in operation, if you press this button.
FAN SPEED
5
Used to select fan speed in sequence auto,
higher, high, medium, low and lower.
SWING
7
Used to stop or start vertical adjustment
louver swinging and set the desired up/
down airflow direction.
10 SWING
Used to stop or start Horizontal adjustment
louver swinging and set the desired left/right
airflow direction.
IFEEL
16
Press to set IFEEL Mode operation.
In IFEEL mode,the Air Conditioner
operates basis temperature sensor
fitted in remote instead of machine,
Advice to use IFEEL mode and the
remote put where the indoor unit
receive signal easily.Press this
button above 5 seconds,start or
stop IFEEL mode.
Smart indicator
S S M M A A R R T T
Low fan speed
Sleep indicator
8℃ Heat indicator
13
13