Sony BKM-101C Manual De Instrucciones página 5

Specifications
About the SDI AUDIO menu
Using the screen menu operation, you can set the sound to
monitor by selecting SDI AUDIO from the main menu.
When you install only the BKM-101C, the 2a menu appears.
When you instal] both the BKM-101C and BKM-102, the 2b
menu appears.
2a| SDI AUDIO menu
(when the BKM-101C is
installed alone)
SDI AUDIO
>» NONE
ANALOG (RGB)
[4 ] Main menu
MENU @ESELECT ems)
CHROMA SET UP
COLOR TEMP/BAL
[2b] SDI AUDIO menu (when
atone both the BKM-101C and
» SDI AUDIO
acne
BKM-102 are installed)
@®SELECT
SDI AUDIO
» CH1+CH2
CH1+CH4
CH1
CH2
CH3
CH4
ANALOG (RGB)
@SSELECT
[1 | Main menu
Select SDI AUDIO and press ENTER to go to the
following menu.
2a] SDI AUDIO menu (when the BKM-101C is
installed alone)
No digital sound signals selected. You can select no
sound (NONE) or analog sound through the AUDIO
IN jack in the analog RGB connectors (ANALOG
(RGB)). [NONE]
SDI AUDIO menu (when both the BKM-
101C and BKM-102 are installed)
Select the digital sound signals output channels or
analog sound through the AUDIO IN jack in the analog
RGB connectors. When you select "CH1 + CH2", you
can monitor the mixed sound from channels 1 and 2.
[CH1 + CH2]
([ ] indicates the factory setting position.)
For menu operation, see the instruction manual that comes
with the monitor.
Input
COMPONENT SDI (V/A) IN: BNC x 2 (active loop through)
Serial digital (270 Mbits/sec)
Quantization: 10 bits /sample
Frequency response: Y: 5.75 MHz, -3dB
R-Y/B-Y: 2.75 Mhz, -3dB
Sony component SDI kit <Audio>
BKM-102 (not supplied)
Input
COMPONENT SDI (V/A) IN: Common with the BKM-101C
Serial digital (270 Mbits/sec)
SMPTE 259M/CCIR 656-HI
Superimposed during H. SYNC
signaling
Quantization: 16 bits/sample
Frequency response: 20Hz-20KHz+1dB
Design and specifications are subject to change without
notice.