Publicidad
Idiomas disponibles
Idiomas disponibles
Guide
Sometimes
you may come across minor problems
that in most cases
do not require a service
call and
can be easily eliminated.
The problem
may have
resulted from improper
handling
and/or installation
of
the appliance.
Please
refer to the below trouble-
shooting guide to assist you in identifying
the
possible cause and solution
to your problem. ShouCd
the problem
still persist
after completing
these
checkpoints.
Contact
the closest
authorized
service
agent in your area for assistance.
The Appliance
Fails to
Operate
After
Connecting
to
Electrical
Power
Supply
• Check the power cord is properly
connected.
• Check the power supply in the electrical
outlet.
(blown fuse / circuit breaker)
• Make sure the appliance
is switched
on.
(thermostat
knob in operating position)
Continuous
Operation
of the
Cooling
System
The door is frequently
opened
or left open for
too long.
° The door is not properly
closed (the door may sag,
the gasket
may be polluted
or damaged).
• Perhaps you may have overloaded
the appliance
with fresh foods.
• The reason
may be inadequate
ventilation
of the
compressor
(assure adequate
air circulation).
Ice Formation
on the
Inner
Rear Wall
As long as the defrost
water runs to the channel
and
through
the outlet to the drain pan on the
compressor,
automatic
defrosting
of the appliance
is assured.
In case the ice formation
on the inner back wa!l is
increased
(3-5 ram), ice should be manually
defrosted.
Set the thermostat
knob to STOP
(0) position
and
leave the door open. Never use electric devices
for
defrosting
and do not scrape the ice or frost layer
with sharp objects.
increased
ice formation
may be one of the following:
the door does not seal well (clean the gasket
if it is
contaminated,
or replace it if it is damaged);
-the
door is frequently
opened or left too long;
-the food stored [n the refrigerator
was warm;
-the food or dish is touching
the inner back wall.
Water
is Leaking
From the
Refrigerator
If the discharge
water outlet is clogged,
or the
defrost
water drips over the channel,
water will teak
from the refrigerator.
• Clean the clogged
outlet, for example
with a
plastic straw.
• Manually
defrost the increased
ice layer. See
"Ice Formation
on the Inner rear Wall"
Noise
Cooling
in a refrigerator-freezing
appliance
is made
possible
by cooling
the system
using a compressor,
which will produce
certain
noise levels. How noisy the
appliance
is depends
on where
it is placed,
how it is
used and how old the appliance
is.
• During
the
operation
of the compressor
the
noise of the liquid is heard and when the compressor
is not operating,
the refrigerant
flow is heard. This is
a normal
condition
and it has no influence
whatsoever
on the lifetime of the appliance.
• After
starting
the
appliance,
the operation
of
the compressor
and the refrigerant
flow may be
louder, which does not mean that something
is wrong
with the appliance
and it has no influence
on the
lifetime of the appliance.
Gradually
the is noise
reduced.
° Sometimes
unusual
and
louder
noise is heard,
which
is rather unusual for the appliance.
This noise
is often a consequence
of inadequate
installation.
-The
appliance
must be level and installed
on a firm
solid base/floor.
-It should not touch the wall or kitchen
units standing
next to it.
-Check
the accessories
on the interior of the
appliance,
they should
be praced correctly
in their
positions;
also check, bottles, tins, and other vessels
are not touching
each other causing
rattling
and/or vibrations.
After defrosting
is complete,
turn the knob to desired
pos[tion
and close the refrigerator
door.The
cause of
l0
Publicidad
