Publicidad
Idiomas disponibles
Idiomas disponibles
COMFORT RANGE
Herschel Comfort
ENGLISH
IMPORTANT SAFETY PRECAUTIONS
Failure to observe these instructions will invalidate the warranty.
Do not disassemble. No user-serviceable parts inside.
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR INJURY
This appliance must be disconnected from its power source during installation or service activities and when
replacing.
The Herschel Comfort is not equipped with an integrated device to control the room temperature and must be
hard wired to a device from our Herschel iQ range (sold separately). If you do not fit a room temperature
controller, DO NOT use for room heating when rooms are occupied by people incapable of leaving the room on
their own, unless constant supervision is provided.
Herschel is not responsible for any breach of EcoDesign (Lot 20) or Safety legislation where the heaters are used in
an enclosed space without use of a Herschel iQ or similar controller.
The Herschel Comfort has internal safety thermal cut out sensors. However, in order to avoid overheating and
DO NOT
DO NOT
potential fire hazard,
cover the heater under any circumstances.
locate the heater within 0.3m
of any flammable materials (eg. Furniture, curtains).
DO NOT
touch the heater when in use. Herschel panel heaters have a surface temperature of around 95°C /
248°F (depending upon input voltage) and prolonged contact with the heater will cause burns and injury.
DO NOT
operate the heater if the cord is damaged or after the heater malfunctions, or if it has been dropped or
damaged in any manner. Check each heater for damage before installation. Make sure that the heater itself and
the cable are free of any visible signs of damage. If the cord is damaged the appliance must be sent for repair to an
authorised Herschel Dealer.
This heater must only be used for the heating of people or buildings. The heater is not to be used by children or
persons with reduced physical, sensory or mental capabilities, or lack of experience or knowledge. Children should
DO NOT
be kept away and should not be left unsupervised around the unit.
use outdoors.
All operators should only switch on/off the appliance provided that it has been placed or installed in its intended
operating position in accordance with these instructions. Children must not switch on or regulate the appliance or
perform user maintenance including cleaning.
Herschel panels are designed for use with an AC voltage between 220-240 volts, 50 Hz AC. If your supply voltage
exceeds 245 Volts do not use the heater and refer to your local dealer. Failure to adhere to this will void the
warranty.
The heater must be mounted on a non-flammable surface.
WATER INGRESS PROTECTION IP44
Herschel Comfort heater panels are rated to a standard (minimum IP44) enabling them to be located within zone 2
in a bathroom. This means they can be placed above a sink or outside any splash zones, or they can be installed on
the ceiling. They cannot be installed in zones 0 or 1.
However, installation in potentially wet or humid rooms such as bathrooms must be carried out by a suitably
qualified installer and comply with local electrical safety requirements. Installation must be such that
the heater must not be able to become detached from the fittings and fall into a bathtub, shower, swimming pool
or other water container and that switches and other controls cannot be touched by a person in the bath or
shower.
If in doubt, do not install. Herschel Infrared Ltd shall not be liable for any loss, damage or injury caused or resulting
from inadequate fitting or incorrect placement of heaters close to water sources.
SAVE THESE INSTRUCTIONS WHICH INCLUDES MODEL AND SERIAL
NUMBER OF THE UNIT (see last page)
Publicidad
