Publicidad
tents for completeness when unpacking. If
any accessories are missing or in the event
of any shipping damage, please notify your
dealer.
Safety devices
Safety devices protect the user and may
not be taken out of operation or functionally
circumvented.
Adhere to the safety instructions in the
chapters!
Symbols on the device
General warning symbol.
Before the initial startup, read
the operating instructions for
the device, battery pack and
charger, as well as all safety in-
structions.
Only use the device indoors
Protection class III
Description of the device
See graphics page for illustrations
Illustration A
Device (MFL means multifunction lamp)
1
Carrying handle
2
ON/OFF switch
3
Lamp
4
USB-C interface, 2.0 A
5
USB interface cover
6
USB-A interface, 0.5 A
7
USB interface activation switch
8
Battery pack mount
9
*Rechargeable battery pack
10
* optional
Rechargeable battery pack
The device can be operated with a 18V
Kärcher Battery Power battery pack.
10
Battery pack charging
1. Charge the battery pack (see operating
instructions and safety instructions for
the battery pack and the charger).
Inserting the battery pack
1. Push the battery pack into the battery
mount on the device until the battery
pack latches into place.
Illustration B
Switching on the device
1. Press the on/off switch.
Illustration C
The battery lamp lights up.
Setting the brightness level
1. Set the brightness level by pressing the
ON-OFF switch.
Illustration C
a Press once: Lamp lights up at the
highest level (280 lm).
b Press twice: Lamp lights up at the low-
est level (80 lm).
c Press three times: The lamp goes out.
Charging external devices
1. Pull out the USB interface cover.
Illustration D
2. Plug the USB charging cable (not includ-
ed in the scope of delivery) into the cor-
responding USB interface.
3. Press the USB interface activation
switch.
Illustration E
The external devices start charging.
Note
To avoid unnecessary battery discharge,
the USB interfaces switch off automatically
after no power has been drawn from them
for more than 30 seconds.
To reactivate them, the activation switch
must be pressed.
The maximum charging current may be
lower for some devices, depending on the
USB device.
English
Installation
Operation
Publicidad
