cecotec CONGA 4000 CARPET&SPOT CLEAN Manual De Instrucciones página 48

ENGLISH
Hose hook
-
Instruction manual
-
3. ASSEMBLY
1. Insert the suction nozzle in the device.
2. Remove the clean-water tank from the main body of the device by pressing the unlocking
tab on the fresh-water tank and pulling out the tank. Fill the tank with fresh water up to the
"MAX" mark and install the clean-water tank back into the main body of the device. Fig. 2
Attention
You can add low-foam detergent to the clean-water tank, combined with water in a 5:10
-
proportion.
- After using your device, you must empty the remaining water in the clean-water tank to
avoid leakage and mould formation.
- Do not shake the clean-water tank during installation, as it could cause water leakage.
4. OPERATION
1. Plug the appliance into a power supply.
2. Press the power button to turn the device on.
3. Press and hold the water release button to spray clean water. Spray clean water on the dirt
to bring it to the surface.
4. Press the suction inlet on the dirt to bring water and dirt to the surface and vacuum them.
Fig .3
5. Stop spraying clean water and vacuum the waste water. After using the device, dry the
surface with a dryer or let it air dry.
6. Switch off the device by pressing the power button.
7. Disconnect the appliance from the power supply.
8. Empty the clean and waste water from the tanks and clean the waste-water tank.
Attention
Do not spray water continuously over the same spot.
-
Take special care when using the device to clean stairs.
-
After using the device, hang and wind the power cord in the power cord holder.
-
Cleaning embedded dirt
Warning:
You can add low-foam detergent in the clean-water tank or apply it directly on the stain.
-
48