Descargar Imprimir esta página

Craftsman 917.28728 Manual Del Operador página 11

Publicidad

Idiomas disponibles

Idiomas disponibles

The operation
of any tractor
can
result
in foreign
objects
thrown
into the
eyes, which
can result
in severe
eye damage.
Always
wear
safety
glasses
or eye shields
while
operating
your tractor
or performing
any adjustments
or repairs.
We recommend
standard
safety
glasses
or a wide vision
safety
mask worn
over spectacles.
HOW
TO
USE
YOUR
TRACTOR
TO SET PARKING
BRAKE
Your tractor
is equipped
with an operator
presence
sensing
switch.
When
engine
is running,
any attempt
by the operator
to leave
the seat without
first setting
the
parking
brake will shut off the engine.
1.
Depress
brake
pedal (B) all the way
down
and hold.
2.
Pull parking
brake
lever
(C) up and
hold, release
pressure
from brake
pedal
(B), then release
parking
brake
lever.
Pedal should
remain
in brake
position.
Make
sure parking
brake
will
hold tractor
secure.
ENGINE
-
o Move throttle
control
(D) between
half
and full speed
(fast)
position.
NOTE:
Failure
to move throttle
control
between
half and full speed
(fast) posi-
tion, before
stopping,
may cause
engine
to
"backfire".
o Turn ignition
key (F) to "STOP"
position
and remove
key.
Always
remove
key
when
leaving
tractor
to prevent
unau-
thorized
use.
o Never
use choke
(N) to stop engine.
iMPORTANT:
Leaving
the ignition
switch in
any position
other than "STOP"
will cause
the battery
to discharge
and go dead.
NOTE:
Under
certain
conditions
when
tractor
is standing
idle with the engine
run-
ning, hot engine
exhaust
gases
may cause
"browning"
of grass.
To eliminate
this pos-
sibility,
always
stop engine
when
stopping
tractor
on grass
areas.
_IOAUTION:
Always
stop tractor
com-
pletely,
as described
above,
before
leaving
the operator's
position.
STOPPING
MOWER
BLADES
-
o To stop mower
blades,
move attachment
clutch
lever
in to disengaged
position
(t_)
Attachment
(r_
} Disengaged
Clutch
Position
Engage Position
GROUND
DRIVE
-
o To stop ground
drive,
depress
brake
pedal all the way down.
TO USE CHOKE
CONTROL
(N)
Use choke
control
whenever
you are start-
ing a cold engine.
Do not use to start a
warm
engine.
o To engage
choke
control,
pull knob out.
Slowly
push
knob in to disengage.
TO MOVE
FORWARD
AND
BACKWARD
The direction
and speed
of movement
is
controlled
by the forward
and reverse
drive
pedals.
1.
Start tractor
and release
parking
brake.
2.
Slowly
depress
forward
(K) or reverse
(L) drive
pedal to begin
movement.
Ground
speed
increases
the further
11
down
the pedal
is depressed.

Publicidad

loading