Descargar Imprimir esta página

Craftsman 917.28728 Manual Del Operador página 13

Publicidad

Idiomas disponibles

Idiomas disponibles

4_CAUTmON: Do not operate the mower
without either the entire grass catcher,
on mowers so equipped, or the deflector
shield (S)in place.
REVERSEOPERATIONSYSTEM(ROS)
Yourtractor is equippedwith a Reverse
Operation System (ROS).Any attempt by
the operator to travel in the reversedirec-
tion with the attachment clutch engaged
will shut off the engine unless ignition key
is placed in the ROS "ON" position.
Ai_,WARNING:
Backing
up with the at-
tachment
clutch
engaged
while
mowing
is strongly
discouraged.
Turning
the ROS
"ON",
to allow
reverse
operation
with the
attachment
clutch
engaged,
should
only
be done when
the operator
decides
it is
necessary
to reposition
the machine
with
the attachment
engaged.
Do not mow
in
reverse
unless
absolutely
necessary.
USING
THE REVERSE
OPERATION
SYSTEM
:
Only use if you are certain
no children
or
other
bystanders
will enter
the mowing
area.
1.
Depress
brake
pedal
all the way down.
2.
With engine
running,
turn ignition
key
counterclockwise
to ROS
"ON" posi-
tion.
3.
Look down
and behind
before
and
while
backing.
4.
Slowly
depress
reverse
drive pedal
to
start movement.
5.
When
use of the ROS is no longer
needed,
turn the ignition
key clockwise
to engine
"ON" position.
ROS "ON" Position
Engine "ON" Position
(Normal Operating)
TO OPERATE
ON HILLS
AI_.WARNING:
Do not drive up or down
hills with slopes greater than 15 ° and do
not drive across any slope. Use the slope
guide provided at the back of this manual.
o Choose the slowest speed
before start:
ing up or down hills.
o Avoid stopping or changing speed on
hills.
o If stopping is absolutely
necessary, push
brake pedal quickly to brake position
and engage parking brake.
o To restart movement,
slowly release
parking brake and brake pedal.
o Slowly depress appropriate
drive pedal
to slowest setting.
o Make all turns slowly.
TO TRANSPORT
When
pushing
or towing
your tractor,
be
sure to disengage
transmission
by placing
freewheel
control
in freewheeNng
position.
Freewheel
control
is located
at the rear
drawbar
of tractor.
1.
Raise
attachment
lift lever to its highest
position.
2.
Pull freewheel
control
out and into the
slot and release
so it is held in the
disengaged
position.
o Do not
push or tow tractor
at more than
two (2) MPH.
o To re:engage
transmission,
reverse
above
procedure.
Transmission
Engaged
Transmission
Disengaged
NOTE:
To protect
hood from damage
when
transporting
your tractor
on a truck or a
trailer, be sure hood is closed
and secured
to tractor.
Use an appropriate
means
of
tying hood to tractor
(rope,
cord, etc.).
13

Publicidad

loading