Exterior Finish
Normally, the exterior surfaces can be cleaned by wiping with a cloth. Paint damage should
be touched up in order to avoid corrosion. All joints and sliding surfaces should be slightly
greased. In the case of heavy contamination, the unit must be cleaned using acid free or water
based solvent or a similar cleaning agent.
Preventative Maintenance
In addition to the periodic inspection procedure, a preventative maintenance program
should be established to prolong the useful life of the chain block and maintain its dependability
and continued safe use. The program should include the periodic inspections with particular
attention being paid to the lubrication of various components using the recommended lubricants
Use only supplied replacement parts. Parts may look alike however the parts are made of spe-
cific materials, processed to achieve specific properties or precisely machined to fit only these
hoists.
Any repairs to this lever hoist must be undertaken by a suitably qualified and competent person.
Following any repairs, this lever hoist must be tested in line with relevant standards prior to its
reintroduction to service.
TRANSPORT, STORAGE, DECOMMISSIONING AND DISPOSAL
Transporting the unit:
• Do not drop or throw the unit, always deposit it carefully.
• Hand chains and load chains must be transported in a way to avoid knotting and formation of
loops.
• Use suitable transport means. These depend on the local conditions.
Storing or temporarily taking the unit out of service:
To ensure the continuing integrity of the unit you should store the unit in conditions that do
not lead to damage or deterioration. Therefore:
• Always store the hoist unloaded.
• The hoist should be secured against unauthorised and unwarranted use.
• Store the unit in a clean and dry place.
• Protect the unit including all accessories against contamination, humidity and damage by
means of a suitable cover.
• Protect against corrosion.
• Wipe off all dirt and water.
• A light oil film should be applied to the chains, hook pins and hook latch pins.
• Since the brake disks may freeze at temperature below 0°C, the unit should be stored with clo-
sed brake. Turn the hand chain wheel clockwise to this effect and hold the load fall at the same
time.
• If the unit is to be used again after it has been taken out of service, it must first be inspected
again by a competent person.
31